– 127 –
TROUBLESHOOTING
2.10 CX
Step
Check
Remedy
YES
NO
1
(Initial Check)
Are any parts broken, malformed, incorrectly installed
or different from those listed in the specifications?
• Principle Parts to be Checked:
(1) Pre-regi. sensor, (2) Feeder assembly
(3) MCU PWB, (4) Harness assembly P/H
(5) LVPS assembly
2
(Check the size of the paper.)
Is the size of the paper in the input tray consistent with
the value set in non-volatile code A?
3
(Check the pre-regi. sensor.)
Is the pre-regi. sensor functioning normally?
• Check using diagnosis code 02.
Replace the part or
install the part
correctly.
See step 2.
Change the value of
non-volatile code A
to be consistent with
the paper size.
See step 3.
See section 3.8
Faulty Pre-regi.
Sensor.
Replace the MCU
PWB.
Summary of Contents for WinType 4000
