– 54 –
REPLACEMENT AND ADJUSTMENT OF PARTS
4.8 CRU Sensor PWB & Actuator
[Disassembly]
Warning:
Turn off the power switch and disconnect the power supply cord from the wall outlet.
Remove the EP toner cartridge and keep it in a safe place.
(1) Turn the printer onto its front. (Turn it sideways so that the front of the printer is pointing downwards.)
(2) Remove the following units:
• Bottom cover (Refer to section 1.4)
• Two screws
[1]
• CRU sensor actuator cap
[2]
• CRU sensor actuator
[3]
• PJ171
[4]
• Two screws
[5]
• CRU sensor PWB
[6]
[Assembly]
Reverse the disassembly procedure.
[3]
[2]
[6]
[4]
[1]
[5]
Summary of Contents for WinType 4000
