3.
Install the Display frame to the Neck
3a) Take care to route the cables from the neck carefully to
aviod pinching, mount the display unit onto the neck. Use
the 1/4” Hex Allen to install the four (4) Socket Head Cap
Screws through the neck mount into the display unit, using
the 4 inner holes. Note: Do not fully tighten yet.
3b) Connect the following wires and cables to the LED display
board as shown:
715-3678 (DC Supply Power Cable) to J20
715-3682 (C-Safe Cable) to J10
715-3781 (Main Interface Ribbon Cable) to J1
4.
Install Left and Right Handrails
4a) Assemble handrail joint as shown.
DO NOT
fasten the (2)
#10 Button Head Socket screws until the following step is
completed.
4b) Install left handrail to the frame as shown using (3) 5/16-
18 x 1.0” socket head screws and (3) 5/16 washers.
Partially lift up the side bed covers, if necessary. Note the
orientation of the mounting plate.
DO NOT
fully tighten
yet. Repeat install for right handrail.
Now tighten Neck, Display and Handrail fasten-
ers. Use the following torque specifacations.
(2)5/16-18 x 3.0” Socket Head screws- 240in-lbs (27 Nm).
(12)5/16-18 x 1.0” Socket Head screws- 240in-lbs (27Nm).
(4) #10 Button Head Socket screws- 35in-lbs (4.0 Nm)
STAR TRAC E SERIES TREADMILL O
WNER
’
S
M
ANUAL
13
Step 4a
Step 4b
J20
J1
J10
