Graphic Display:
Traces your progress through each of the programs and allows you to anticipate changes in terrain. Display elements
illuminate from left to right across the bottom of the display to indicate your progress through the course. At each step, display elements
illuminate in columns to indicate your ascent up the gradient that is in effect.
Motivational Track:
Shows your progress counter clockwise around 1/4 mile (400-meter) course, starting from the bottom center.
Speed Keys:
During Program setup, press the
or
keys, respectively, until the desired speed appears in the
Information Window, then, press S
TART
or
key. During a Program, press the
or
keys, respectively, to
increase or decrease running belt speed in 0.1 miles per hour (mph) or 0.1 kilometers per hour (km/hr) increments. Speed
cannot be higher than the established “MAXIMUM SPEED” parameter (see Chapter 8.) These keys repeat when pressed
and held.
Speed Window:
Shows the speed at which the user is walking/running, from 0.5 mph (0.8 kph) to 15 mph (24.0 kph).
Incline Keys:
Adjust treadmill incline in 0.5% increments from 0% through 20% in manual operation. These keys
repeat when pressed and held.
Incline Window:
Shows the incline that the user is ascending, from 0% (easiest) to 20% (most difficult).
Numeric Keypad:
Allow you to enter specific values for program parameters during program setup. The numeric key-
pad can also be used to adjust treadmill speed while the treadmill is operating.
Time Window:
Shows the duration of your workout thus far in minutes and seconds.
Distance Window:
Shows the total number of miles or kilometers you have walked or run thus far.
Calorie Window:
Shows your aggregate caloric expenditure thus far in your workout.
Heart Rate Indicator:
Pulsates to indicate your heart rate has been acquired through the use of the heart rate strap
or heart rate grips.
Fan Key:
Allows you to control the speed of the personal cooling fan, either OFF, LOW or HIGH.
Heart Rate Display:
Shows your current heart rate in beats per minute (BPM) while wearing the heart rate strap or grasping the heart
rate grips.
PROGRAM Keys:
Allow you to access a desired workout program.
Information Window:
Provides informational messages, prompts during program setup, notification when your workout is complete,
and scrolling summarized workout data during and after a workout. Depending on the program completed and treadmill settings as set
in Maintenance Settings mode, workout data may include:
HOT BAR CONTROL FEATURES
Your Hot Bar provides you with the following operating controls:
Speed/ Incline Button: Push “+” down on the dual-action button or
away to increase the speed. Push “-“ down or pull to decrease the
speed.
Stop Button: Push on the red Dual Purpose Stop Button to stop
the treadmill or to reset after the emergency lanyard has been
pulled.
Safety Lanyard: Clip on the Safety Lanyard to your shirt for prop-
er application. A tug on the cord will trip the emergency stop
switch and the treadmill will stop operating. Press on the red Dual
Purpose Stop Button to reset the treadmill.
Headphone Jack (optional): Plug in the 1/8” plug of the head-
phones into the headphone jack to listen to audio or programs.
18
STAR TRAC E SERIES TREADMILL O
WNER
’
S
M
ANUAL
I
Time remaining
I
Distance remaining - miles or kilometers
I
Laps completed
I
Calories expended per hour
I
Minutes per mile/kilometer
I
Vertical distance travelled - feet or meters
I
METS
I
Heart Rate
I
NCLINE
S
TOP
S
PEED
S
AFETY
L
ANYARD
H
EADPHONE
(O
PTIONAL
)