Page 11
Headphone Jack - Units without Hotbars
For units without hot bars including the 8G, 8-UB, 8-RB, the following steps must be completed after
primary installation of the PVS and controller. The headphone jack goes directly into the console
with a new bar replacing the existing USB/HDMI bar.
1.
Use a #2 phillips screwdriver to remove the two
screws from original USB panel, remove the
panel, then disconnect the USB cable from the
USB board.
2.
Connect the USB cable and HDMI cable to the
new panel, connect the headphone jack to the
panel using the small Phillips screw, then apply
the overlay to the panel. Finally, install the panel
into the console.
3.
Use the headphone extension cable to connect
the headphone jack on the panel to the PVS.
Connect the angled side of the cable to the panel
jack.