Page 3
Please note that while the images below show a PVS installation onto a treadmill, the steps are
valid for ALL units.
1.
Use a Phillips screwdriver to remove the screws
securing the front of the console to the console
rear shroud. Take note of console connections,
disconnect wiring from mast to console, and
remove console front.
TECH TIP:
Take a picture of the connections
before removing them.
2.
Use a #2 phillips screwdriver to remove the two
(2) screws securing the top cover to the upper
inside rear shroud, then remove the top cover.
Save the screws for use in connecting the new
PVS top cover in Step 4.
3.
Slide the console top cover onto the PVS bracket.