14
620-7991 Rev 002
STEP 13.
Note:
If the iPod cable comes pre-installed on the cradle,
skip this step.
Take the iPod® cable from the kit. Install the
cable into the iPod
®
cradle on the front side of
the display console by removing the plug from
the cradle then inserting the cable through open-
ing. Make sure cable is aligned properly with the
display plastics. Press firmly to ensure the cable
is seated into the cradle.
STEP 14.
With the center console now installed, it is time
to attach the USB cable, center console ribbon
and the iPod® cable. Take the USB cable from
the center console and attach it to the
CCB J14
connector on the display board. Next take the
center console ribbon cable and attach it to the
display PC board. Then take the iPod® cable
from the base of the mount to the center con-
sole. Tie the iPod
®
cable to the plastic using the
3.5” tie wrap.
STEP 15.
Next replace the bottom cover. Using a #2 Phil-
lips head screwdriver, replace the (4) screws
that hold the bottom side of the display console
on. Then plug in the CSAFE cable to the back of
the display board.
Make sure pin one on the cable is connected to pin one on the board.
Summary of Contents for E-RBi
Page 2: ...2 620 7991 Rev 002 ...
Page 50: ...50 620 7991 Rev 002 ...
Page 51: ...51 620 7991 Rev 002 ...
