CrossTrainer Service Manual
21
CrossTrainer Service Manual Rev A 620-7575
Part Installation Procedure - Keypad
Parts Needed:
x
Keypad Overlay (050-1923)
Tools Needed:
x
Phillips
Screwdriver
Procedure:
Remove the Old Keypad
1. Remove the back display housing.
x
Remove the 7 screws from the back of the display housing
x
Pull the back housing off display.
2. Remove the fan bracket.
x
Remove the 4 screws from the fan bracket.
Note: Before removing the last screw, be sure to have a hold of the fan bracket. The fan
wire will still be connected to the display electronics.
x
Carefully unplug the fan. Do not tug aggressively or you may pull the connector from the
display.
3. Remove the display electronics.
x
Unplug all the cables from the back of the display.
x
Remove the 5 screws that are holding the electronics to the display panel. Set the
electronics aside.