CrossTrainer Service Manual
24
CrossTrainer Service Manual Rev A 620-7575
Part Inst. Procedure - LCB, Batt. And UB Board (cont.)
Remove the LCB Plastic Shield
1. Turn the two plastic thumb screws to loosen the top of the LCB shield. Note: There is a thumb
screw on the bottom of the shield but it may not be necessary to loosen it to service the LCB.
LCB Replacement
Remove the Old LCB
1. Unplug all 6 (7 for Elite) cables from the LCB.
2. Use the short Phillips head screwdriver to remove the 2 screws holding the LCB to the frame.
Note: Be careful not to drop the screws in the frame.
Install the New LCB
1. Place the new LCB in the frame.
2. Use the short Phillips head screwdriver to install the 2 screws to hold the LCB to the frame.
3. Plug in all cables to the LCB.
4. Before installing the UB shroud panel, test for functionality.