10
Shoulder Chest
INSTRUCTIONS
NOTE
: Take special care when unwrapping unit,
DO NOT
use knifes to cut open packaging damage may
occur.
STEPS:
1. Take main body off the pallet and place it on the floor.
2. Attach the (2) lower arms to their respective sides of the main body.
(Note: cables are attached; take special care not to pinch, twist, or damage cables. Make sure the
cables travel straight).
Use (4) M12 washers and (4) M12 x 30 – button head screws to attach each assembly to the main
body, tighten fasteners to (84 NM / 62 ft-lb) torque.
3. Attach the (2) upper arms to their respective sides of the main body.
(Note: cables are attached; take special care not to pinch, twist, or damage cables. Make sure the
cables travel straight).
Use (4) M12 washers and (4) M12 x 30 – button head screws to attach each assembly to the main
body, tighten fasteners to (84 NM / 62 ft-lb) torque.
4. Take the seat pad assembly; remove M6 Phillips head screw and washer. Slide seat pad assembly into
main body; re-install M6 Phillips screw and washer.
5. Attach accessories to the unit.
6. Place urethane boots under feet.
