Assembly & Setup
Star Trac Spinner
©
NXT Black Belt Installation
A
ssembly &
S
etup
Use the following procedures to unpack and assemble your
Star Trac SPINNER
®
NXT Black Belt™
.
UNPACKING
AND
PARTS LIST
Position the shipping carton so the “Heavy End” logo is located at the bottom. Open the top of the carton and fold back all four flaps.
Carefully tilt the box forward so that the box may be lifted to expose the bike. Remove all parts from the shipping carton and foam
inserts, and verify that the following parts are included in your shipment:
NOTE:
All tools required to assemble the bike are included within the packaging, except for a Rubber Mallet, which is recommended
when assembling the pedals onto the bike.
NXT Black Belt Parts List
Description
Qty.
Description
Qty.
Main Frame Assembly
1
M8x1.25x14 Specialty Hex Bolt
2
Handlebar Post
1
M8x1.25, 30mm Hex Head Bolt
4
Handlebar w/ Grip & Water Bottle Holders
1
8mm Split Lock Washer
4
Seat Post
1
8mm Plain Washer
4
Seat Slider Assembly w/ Saddle
1
Wrench Hex, 4mm
1
Front Leg Assembly w/ Transport Wheels
1
Wrench Hex, 8mm
1
Rear Leg Assembly
1
Multi-Wrench
1
Pedals (set of two)
1
Spare Parts Kit (includes brake pad and pedal
1
straps)
Spare Parts Kit
- Save the box of spare parts in a safe place so you have service parts when needed in the future.
Take time now to enter your Spinner NXT Black Belt serial number in the space below (serial number is located on underside the
bottom rear cross member).
If parts are missing, or if you have any operational questions, please call Star Trac’s Service department at (800) 503-1221.
Have your serial number ready.
Serial No.
NOTE:
If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been
overlooked.
If parts are missing, or if you have any product questions, please call Star Trac’s Service Department at (800) 503-1221, please have
your bike’s serial number ready.
CAUTION:
Damage to the bike during assembly is not covered as part of the limited Star Trac warranty. Take care not to drop or lean
the bike on the handle bar pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip over
during assembly.
