Assembly & Setup
4. Remove the following: handle bar & its packaging (Fig. 4)
from the center packed location.
Fig 4
5. Remove the: hardware pack, seat, handle bar post, and seat
post from the foam covering the front section of the Spinner
frame (Fig. 5).
Note:
Do not remove any tape holding the two front foam
packing half’s until step 11.
Fig. 5
6. Tilt the packaged Spinner frame towards the heavy flywheel
end (Fig. 6) and remove the following: front foot assembly,
pedal set, & the rear foot assembly from their packaged
location.
Fig 6