Assembly & Setup
7. Remove the foam packaging from the rear section of the
Spinner frame (Fig. 7).
Fig. 7
8. Locate the rear foot assembly along with the corresponding
hardware that secures it to the Spinner frame (Fig. 8).
Hardware
:
M8x1.25x30mm Hex Head Bolt 8mm
Split Lock Washer
8mm Plain Washer
Qty:
2
2
2
Fig. 8
9. Install the rear foot assembly (Fig. 9) and tighten hardware
using the supplied multi sized open wrench.
Note:
These bolts must be torqued between 35-40 Lb-Ft (47-
54 Nm).
Fig. 9