20
| TURBO TRAINER Manufactured by STAR TRAC OWNER’S MANUAL
19. Insert the assembled seat post (Fig. 20) into the frame by
pulling on the pull pin located on the upright column of
the frame and sliding the post downward along with the
plastic sleeve verifying to lock the post into one of the
available positions.
Fig. 19
20. Mate the edge of the plastic sleeve flush with the edge of
the upright tube (Fig. 21) and install the corresponding
hardware to lock the plastic sleeve in place.
Hardware
QTY
M4 x 10mm Phillips Pan Head Thread Form
Screw
2
Fig. 20
21. Review all areas of the machine to verify no hardware
was left loose and install the leveling feet. Adjust each
leveling foot (Fig. 21) if needed to compensate for
uneven ground.
Fig. 21
