Star 11 QUART, Installation And Operation Instructions Manual

5

CLEANING INSTRUCTIONS

IMPORTANT: Stainless steel may corrode if not cleaned properly.

Clean and dry the heated bowl inside the warmer every night. Use a soft cloth and mild soap to keep 
exterior surfaces bright and shining. To keep the inside surface of the bowl clean, use S.O.S. or Brillo 
pads as often as necessary. Do not use detergents, strong abrasives or metal scouring pads on exterior 
surface of warmer.                 

DO NOT IMMERSE IN WATER AT ANY TIME.

PUMP CLEANING

Before using and at least daily, disassemble the pump and wash all parts.

To disassemble pump:

.  Unscrew nut-cylinder.  Pull pump-plunger from pump chamber.

.  Unscrew knob from plunger assembly and disassemble.

.  Unscrew cap-tube and nut-sleeve-tube from dispense tube.  Remove cover from pump  

assembly.

4.  Remove pin "U" from pump assembly and disengage dispense tube from pump chamber.

5.  Remove balls from pump chamber.

6.  Wash all parts thoroughly in hot soapy water and rinse thoroughly.  Use 8" long brush to clean 

inside of dispensing tube.  Reassemble pump.  When reassembling pump, wet o-ring with edible 
vegetable oil, then reassemble.  Make sure all parts are in their proper place.

SANITIZING PUMP ASSEMBLIES 

It is recommended that the pump assembly be sanitizied after routine disassembly and cleaning.  Prepare 
a 00 ppm quaternary solution (similar to Pro-Quat 0). Immerse all pump parts in this solution for at 
least 60 seconds, remove and let air dry. Reassemble the pump.

PRIMING PUMP

Three () strokes of the pump plunger are necessary to initially prime and vend thick food products.

FAILURE TO DO THIS CAN CAUSE A BROKEN "O" RING TO BE PUMPED 

OUT WITH THE FOOD BEING VENDED.

SIGN REPLACEMENT 7WL AND 11WL MODELS

.  Unplug cord from the receptacle.

.  Remove two screws in the sign retainer fastened to the bottom.

.  Pull forward on the bottom edge of the plastic panel and remove it. 

4.  Replace the sign.

5.  Place the front plastic panel back into its original position.

LIGHT BULB REPLACEMENT  11WLA MODELS

.  Unplug cord from the receptacle.

.  Remove both front panels as stated above.

.  Replace bulbs with a  5 watt appliance type,medium base for 0V or a 0 watt medium base for 

40V.

MAINTENANCE AND REPAIRS

Contact the factory, a service representative or a local service company for service or required 
maintenance.

CAUTION

CAUTION