Temperature:
1. To view the actual temperature, press
and hold "Temp Button". Display will
read "Lo F" if temperature is below
273°F and "Hi F" if temperature is
above 573°F.
To Program Time and Temperature:
1. Press and hold "Temp" (actual
temperature displays).
2. While holding "TEMP", press and hold
any program button on the Left PC
board for 1 second, the LED above
program lights and display reads
"_ _ _ _". Enter the four - digit
security code sequence,
4, 3, 2, 1
.
Starting with the first digit, the center
horizontal bar will light on each digit
as the security code is entered. The
security code
will not
show on
display. Once the correct sequence
has been entered, the preset time will
be displayed and the LED for that
program will begin to flash.
3. Set the time with the "+ or -" buttons.
4.
Press the "TEMP" button to save the
time.
5. The preset temperature will now be
displayed.
6. Set the desired temperature for this
program using the "+ or -" buttons.
7.
Press the "TEMP" button to save
temperature and to exit
programming mode for this
program.
The LED will stop to flash
but will remain lit.
8. Press any other program button
within 15 seconds to continue
programming without re-entering the
security code.
3. While programming a program (LED is
flashing), if no input is received for 15
seconds, the unit will revert to normal
operation and the security code must
be re-entered.
Note: Temperature settings are done
with the
Left PC board
only. The time
settings programmed on the Left PC
board will also be programmed onto the
Right PC board.
See below to make
changes to the
Right PC board
only.
Each programming change must be
saved by pressing the "TEMP" button!
Right PC board (Timer only):
1. To Change the time on Right PC
board, press and hold the "TEMP"
button on the Left PC board and press
and hold any program button on the
Right PC board for one second. The
LED above the program button will
light and the Right Display will read
"_ _ _ _". Enter the four-digit security
code sequence,
4, 3, 2, 1.
Starting with the first digit, the center
horizontal bar will light on each digit
as the security code is entered. The
security code
will not
show on
display. Once the correct sequence
has been entered, the preset time
will be displayed and the LED for that
program will begin to flash.
2. Set the time with the "+ or -" buttons.
3.
Press the "TEMP" button to save the
time.
4. The LED will stop to flash but will
remain lit.
5. Press any other program button
within 15 seconds to continue
programming without re-entering the
security code.
6. While programming a program (LED is
flashing), if no input is received for 15
seconds, the unit will revert to normal
operation and the security code must
be re-entered.
Operation:
1. Pressing any program button (1-4) will
start the timer countdown and display
the preset time remaining. The LED
for the appropriate program will be lit
during countdown and remain lit until
another program is selected.
2. When the display reaches "00:00", the
buzzer will sound and the digits will
flash.
3. Press the program button to silence
the buzzer and return the readout to
programmed time.
4. The Right and Left boards will operate
independent of each other. Both
timers can be in operation at the same
time. The "00:00" display will show
which side is timed out.
2
