To program Security Code:
1. With power
OFF
, hold buttons #1 and
#2 on the
LEFT
board and turn
ON
the power switch. The digits will show
the current Security Code.
2. Press "TEMP" button to return to
normal operation, or to make changes,
using the program buttons, enter new
four digits Security Code 1, 2, 3, or 4.
3. Press "TEMP" to save and return to
normal operation.
NOTE: A factory default Code may be
hard programmed if desired.
CORD WITH 20 AMP PLUG
Two cord take-up brackets are located on
the bottom of the unit. These brackets
are to be used to wrap up the excess
cord in the event that the plug-in
receptacle is located close to the unit.
These brackets will prevent accidental
damage to the power cord and prevent
entanglement in the working
mechanism of the unit.
MONTHLY LUBRICATION/
INSPECTION
1. Apply two (2) drops of nontoxic
mineral oil onto counter balance shaft
and bronze nylon spacer.
2. Check all bolts/screws and tighten if
necessary.
CLEANING
All surfaces except the cooking grids are
stainless steel and can be cleaned with a
warm, damp cloth and detergent.
CAUTION
DO NOT IMMERSE OR LET THE
UNIT STAND IN WATER.
DO NOT HOSE DOWN.
KEEP AWAY FROM RUNNING
WATER.
To remove burned on grease or food
residue use the following mixture:
1 Tablespoon liquid dish detergent
1 Cup of warm water
CAUTION
For models with #4 programmed for
"CLEAN" mode:
1. Press #4 button.
2. Open toaster to allow faster cooling.
3. Alarm will sound when toaster is
350° F.
4. Turn unit OFF.
5. Unplug the unit.
6. Begin toaster cleaning procedure
using answer system book 5, under
toaster.
BEFORE CLEANING ALL OTHER
UNITS MAKE SURE POWER IS
TURNED OFF AND UNIT IS
UNPLUGGED.
While holding top lid with one hand,
apply this mixture to cold or warm top
cooking surface with a sponge or plastic
scrubbing pad. Wipe with clean sponge
or towel until it is clean.
DO NOT SPLASH CONTROL
HOUSING!
Do not splash metal conduit connecting
top and bottom of the toaster!!
Empty and clean grease catcher cup as
required using detergent and water after
removing cup from unit.
MAINTENANCE AND REPAIRS
Contact the factory, a service
representative or a local service company
for service or required maintenance.
RETAIN THIS MANUAL FOR FUTURE
REFERENCE
PART NO. 2M-Z2153 REV. A 8/24/99
3
