Star Lang 124S, Installation And Operation Instructions Manual

6

EQUIPMENT DESCRIPTION

Exterior Construction

The griddle dimensions are 17” (43.18cm) High, 30” (76.20cm) Deep, and width is dependent on the 
actual model number. 
The Sides, Bottom, and Rear wall are constructed of double wall stainless steel, which allows closer 
installation to combustible surfaces. 
The griddle surface is made of 1” thick, highly polished steel to reduce hot and cold spots, recovery 
problems, warping, and ensure even heat to the edges of the griddle.

Controls

Each twelve-inch section has its own temperature selector switch that snaps into place to lock in any 
temperature from 175°F to 450°F (79°C to 232°C) in 25° increments.
Each twelve-inch section of the griddle is controlled by an area sensitive RTD probe, which can sense 
and react to a temperature change of +/- 4°F.
Each twelve-inch section has a set of 6 K.W. elements for high ef

fi

 ciency, quick recovery and outstanding 

performance

Technical

The 100 Series Selectronic griddle operates on either 208/240V or 480V, at either single or three phase. 

This must be speci

fi

 ed when ordering. 

Minimum clearances: 2” from side and back

 NOTICE 

The data plate is on the right side of the griddle.  The oven voltage, 
wattage, serial number, wire size, and clearance speci

fi

 cations are 

on the data plate.  This information should be carefully read and 
understood before proceeding with the installation.

1” Griddle Surface

Gutter

Legs

Grease Pan

Section

Temp. Dial

Main Section

Power Switch

Section

Power Switch

Rear Gutter

(certian models)

IL1548