-21-
6-6-3 Commands for IC card
MCP310TD/MCP390TD
<Note>
These commands are only to communicate with specified IC chip card and the
further IC card commands are regarded as confidential.
Please contact your card manufacturer to receive further information.
(1) IC Card Mount
This command transfers the card to the IC contact and activates the card.
The data line shows Answer To Reset (ATR) data.
(2)IC Card Dismount/Stand by
This command deactivates the card.
(3) IC Card Communication (8K bit card)
This command sends specific IC commands to IC card. The commands depend
on IC card specification.
The command data line has to be the 6 bytes data line, with Byte-1 through Byte-
3 of the IC card commands characterized.
To send the read command, please put the number of data bytes in to Byte-3.
When failing to write data (such as writing the same data), status returns an error.
Refer to the IC card specification for detailed information
STX
80h
ETX
BCC
Command format
STX
80h
Status
Data
ETX
BCC
Response format
STX
83h
ETX
BCC
Command format
STX
83h
Status
ETX
BCC
Response format
STX
84h
Command data
ETX
BCC
Command format
STX
84h
Status
Data
ETX
BCC
Response format
Summary of Contents for MCM300 SERIES
