2-6
English
StarBoard Link EZ2-Pen
Assembly and Setup
2.2.4 Adjusting the Sensor
2.2.4.1
Sensor Adjustment Procedure (Windows version)
(1) Start "SBAdjust.exe" (When first connected via USB, it starts automatically).
Select "MENU" – "Settings" – "StarBoard" – "StarBoard Settings" and press "Sensor
adjustment" in the StarBoard toolbar.
Alternatively,
Run "SBAdjust.exe" located under "My Computer"
→
"C Drive" (*)
→
"Program Files"
→
"Hitachi Software Engineering"
→
"FX-DUODriver"
(*)This folder path may be changed since it depends on your Windows installation.
(2) Touch the center of the blinking mark with the pen tip.
*Hold the pen upright to the installation surface.
*Do not move the pen until the display in the progress bar reaches 100%.
NOTICE
Using infrared and compact cameras, this product captures the image (reflected
light) of a pen and detects the corresponding coordinate position. Do not operate
near lighting that will obstruct the capture of the image.
- Locations where the surface or side of the projection area are exposed to direct
sunlight.
- Locations in which there are light fittings with many light bulbs or infrared rays
directly above the projection area.
- The place where there is some reflective object around projection area.
(Reflective bars or pen which are not used, interactive white board built-in reflection
tape, etc...)
Summary of Contents for Link EZ2-Pen
Page 2: ......