2-9
English
StarBoard Link EZ2-Pen
Assembly and Setup
(4) The calibration screen starts.
Use the pen to click on the center of the flashing circles in order. Continue pressing the pen to
the center to a circle until it turns from red to green. If clicking is performed properly, the circle
turns grey.
*Hold the pen upright to the installation surface.
Once you click on the center of all nine circles, a dialogue box that says "Calibration completed"
is displayed. Press "OK" to finish calibration.
This completes sensor adjustment.
2.2.5 Positioning Alignment
Select "MENU" on the StarBoard Software toolbar
→
"Settings"
→
"StarBoard"
→
"Calibrate"
→
"OK". and then perform position alignment.
Summary of Contents for Link EZ2-Pen
Page 2: ......