Technical Primer - Aurora
4
Installing and Connecting the Charger
4.1
Package content
Content of the package of the charging station consists of
• Aurora Charger
• Installation manual
• Wall mounting block and assembly accessories
• 2 RFID charge cards (depending on the selected options)
4.2
Installations site requirements
While selecting a location to install the Aurora, the following criteria must be taken into account:
• The charger should not be installed close to dangerous and explosive locations. E.g Water
Sources, Gas and Steam pipes.
• The installation location should be convenient for charging. While installing the charger, wiring
length should be shortened as the cable resistance reduces and the power loss through the wire
reduces as a consequence.
• The installation position of the charging pile should not be set at a place where the terrain is
low. The installation should be vertical and the center of gravity be adequate to prevent tipping
or tilting. The charger should not be placed in an environment subject to severe vibrations or
high temperature.
N.B. - The recommended installation height is 70 to 120cm from the ground to the bottom side
of the casing. The installation site must have a levelled and solid underground.
• The wall-mounted charging pile must be connected to the wall at least two points. The wall
should withstand the weight of the charging pile and its accessories. The wall and internal
lines should not be too close.
• The indoor installation protection level should be at-least IP32, and the outdoor IP54. It is
recommended that the charger be installed in an environment with a sunshade.
• The charging cable (approx. 5-meter length) must not be under tension while connected to the
vehicle.
• Space should be reserved for the engineering personnel to open the back plate of the equipment
for inspection and maintenance. Ensure that the grounding of the charger is properly connected
and inspected.
• It is recommended that customers install a circuit breaker in front of the charging pile. The
miniature circuit breaker (MCB) needs to meet local regulations.
• Prevent road users from being able to drive over the cable and pedestrians from being able to
trip over cables.
• Ensure that the UTP/Ethernet connection on the bottom side of the charging station is covered
to prevent it from being unintentionally disconnected or used by unauthorized individuals.
• Always fully comply with local technical requirements and safety regulations and the following
ambient conditions needs to be maintained.
Maximum atmospheric humidity of 95%
Ambient temperature of -30°C to 50°C.
Wanbang Digital Energy Co.Ltd
12
