Fig.9
A. Setting Lower Limit:
1) Press
key and key at the same time for at least 3 seconds.
2) When alarm sounds, Speed Indicator will change to "
" (Lower air pressure limit setting mode).
3) Press the key, Speed Indicator flashes "
" and " ".
4) Press the Foot Pedal of the delivery unit, Speed Indicator shows the present air pressure. (Unit is kgf/cm
2
)
6. Convenient Functions
(5) Select FWD/REV rotation using the FWD/REV Select Key. (Fig. 9)
Lamp ON
REV
Lamp OFF FWD
(6) The micromotor operation is controlled by the Air Switch/Foot
Pedal of the delivery unit.
(1) Foot Air Calibration
By using this function, you can to use the maximum speed, 40,000 min
-1
(rpm). You must set the upper and lower limit
of the air pressure to enable this function.
Perform this adjustment function after your purchase. Once it is adjusted, it will be memorized, and there is no need
to do this everytime.
NOTICE
· The displayed air pressure is only a guideline. Measure the correct air pressure with an air gage.
· The unit of displayed air pressure is "kgf/cm
2
". For other units, refer below.
ex) 0.1kgf/cm
2
= 0.01MPa = 1.42psi
1.0kgf/cm
2
= 0.1MPa = 14.22psi
3.0kgf/cm
2
= 0.3MPa = 42.67psi
5) Press the Foot Pedal of the delivery unit, and hold the air pressure between "
" - " ". Press
key for at
least 3 seconds to save the lower limit of the air pressure.
Fig.8
(4) Set the maximum speed using the speed control switches. (Fig. 8)
NOTICE
Push
6
Speed Up
Speed Up
Speed Down
Speed Down
Set maximum Speed
Set maximum Speed
Lamp illumniated only during REV rotation
Lamp illuminated only during REV rotation
Push
