Stardom SOHORAID SR2, User Manual

SR2 Series User Manual

4

4. Hardware Installation Procedure

Please follow the instructions below to complete the hardware installation.

Place the system on a stable surface. Ensure that it is well ventilated without blockage to 

the vent and kept away from areas near water and damage prone areas.
Use the ejector pin included in the accessory kit and inserted into the pin release opening to 

eject the removable drive tray latch and extract the removable drive tray.
For 3.5" HDD/SSD, please secure it by use six the larger screws included in the accessory 

kit. For 2.5" HDD/SSD, please secure it by use four the smaller screws included in the 

accessory kit.

Step 1

Step 2

Step 3

Step 4

Step 5
Step 6

Step 7

Step 8

When the hard drive installation has been completed, insert the hard drive tray into the 

system horizontally and secure the latch into place.
Connect power cable to your power outlet and SR2.
Depending on the type of computer USB port, select the corresponding USB cable in the 

accessory to connect the computer to the USB port on the SR2.
First turn 

the main power switch on the back of the product

 to “I” to turn the power on, 

the power touch switch on the front of the product

 will light red, then gently press 

the 

power touch switch on the front of the product

 until the power symbol “ ”  turns into a 

blue light.

When the LCM display shows the following picture, the power on is complete.

Note: Please avoid using hard disk drives from different manufacturers or different 

models from the same manufacturer as this may impact system performance.

※

 The factory default value of SR2 is RAID 1 mode.

RAIDON RAIDbox2  

RAID-1 vxxxxxx.x

Pri HDD : OK

Sec HDD : OK

If you are not using the product for a while, you can put the product into shutdown mode: 

first press 

the power touch switch on the front of the product

 until the power symbol “   

” is off; if you want to use the product, gently press 

the power touch switch on the front of 

the product

 until the power is turned on. The symbol “   ” is illuminated.

If the product is not used for a long time, please turn off the product main power switch: first 

gently press 

the power touch switcth on the front of the product

 until the power symbol 

“ 

 ” is off, then turn 

the power main switch on the back of the product

 to “ O ” to turn off 

the power. 

Step 9

Step 10

※

  If you are using a USB 3.2 C to A cable, the Type-A on the host side needs to be USB 3.2 Gen2 

for best access performance.