Please ensure each
plug has connected
tightly before turn
on the power.
1
2
3
4
eSATA
SA
T
A
S
ATA
SA
T
A
SA
T
A
SATA Port
ST5610 eSATA Ports
SATA Bracket
eSATA cable
1. Please use a motherboard with SATA II (3.0 GHz) interface to enhance compatibility and transmission efficiency.
2. PCI-X SATA II and PCI-E SATA II are available on the STARDOM web site for customers who do not have the SATA II
interface on their motherboards or are in need of high-speed data transmission.
3. Please purchase an interface card supporting at least 4Ports SATA II (3.0 GHz) .
4. As for the installation of connecting wires, please use eSATA connecting wires and SATA bracket which are in the
accessory package and abiding by SATA using standard.
Computer Case
5
Hardware Installation Procedure
Ｄ
.Carefully push the removable tray into the slot and push the handle back into place as
shown in Figure 4.
3.Connection Wiring Installation
A.External
Case
Mode
a.Connect one end of the eSATA II bracket-to-SATA cable to the SATA interface on the
motherboard or another SATA II card (Note 1) and connect the other end of the eSATA
II bracket-to-SATA cable to the eSATA port on the ST5610. Make sure the screws on
the bracket are fastened and the eSATA connector is secured as shown in Figure 5.
b.After ensuring the device is installed successfully, power on the ST5610 first and then
turn on the PC when the ST5610 runs normally.
(Figure 4)
(Figure 5)
