NG FIRE PIT AND BURNER INSTALLATION INSTRUCTIONS
- 5 -
COPYRIGHT ©
2020
, STARFIRE DIRECT, ALL RIGHTS RESERVED.
FIG. 5-1
FIG. 5-2
1.
Place
Fire Pit
over
Gas/Electrical Utilities
.
2.
The f
l
ex lines attached to the
Gas Key Valve
have been pre-tightened. Using two
ad
j
ustable
wrenches, ma
k
e sure the
y
are nice and tight
and did not loosen during shipping.
3.
Remove the drop in burner from the box.
4.
Both
of the flexible gas lines will have a
FLR x FIP
fitting hand tightened at the end.
Attach
the Flex line with the yellow tape to the burner pan. Attach the other line to your gas supply.
REMEMBER: Use “Pipe Joint Compound” or “Yellow Gas Tape” on all NPT fittings.
NEVER USE ON COMPRESSION THREADS!
4.
Using two ad
j
ustable wrenches, tighten the end of the first flexible gas line to the
compression fitting
on your
gas stub.
5.
Using two ad
j
ustable wrenches, tighten the end
of the second flexible gas line
(with yellow tape)
to
the compression
fitting on the bottom side of the
Burner System
.
M
a
k
e sure all fittings are tight and
secure, then set
the
Burner System
into the
Fire Pit
.
6.
Test your connections for leaks before
first use.
Use a soapy water solution.
7.
Before placing lava rock in burner pan, light your
burner to ensure proper ignition. For lighting
instructions, see page 8.
NOTE:
These instructions are only for
Natural Gas installations
.
To convert your fire pit for use
with propane, see page 6.
