TECHNICAL INFLORMATION
3
PARTS INFORMATION
OPERATION
DIRECTION OF
ROTATION KNOB
SQUARE DRIVE
HEAD
TRIGGER
AIR INLET
AIR SYSTEM
Always use a clean, dry, regulated, compressed air at 4 to 7bar (60 to 100PSI)
Do not exceeed the maximum and minimum pressure. Operating the tool at the wrong pressure. Operating
the tool at the wrong pressure (too low or too high) will cause excessive noise or rapid wear.
It is recommended that a filter-regulator-lubricator be used and be located as close to the tool as possible.
If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the air inlet plug
before each use.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will reduce the air pressure to the
tool, which will cause reduction in power, efficiency and general performance.
LOADING AND OPERATION
1. Plug in the compressor, turn it on and set the pressure regulator to 90PSI. Attach one end of the air hose to
the compressor and the other end of the air hose to the tool. Use plumber’s tape to avoid an air leak.
2. Place and lock the socket over the square drive of the air-powered impact wrench.
3. Place the socket over a nut to be removed or installed and press the trigger at the top of the handle to operate
to tool
4. For reverse rotation, press the speed control knob on the left side of the tool. For forward rotation, press the
speed control knob on the right side of the tool. Rotate the speed control knob on the left side of the tool during
reverse rotation to control the speed of the air flow as required. Rotate the speed control knob on the right side
of the tool during forward rotation to control the speed of the air flow as required.
5. After using the tool, disconnect the air hose from the tool.
Summary of Contents for 44421
Page 6: ...TROUBLESHOOTING 4 ...