Stark 61021, Owner'S Manual And Safety Instructions

PLATE COMPACTOR

13

When adjusting the belt(s), make 
sure that the clutch pulley is in 
alignment with exciter pulley.

When the V-belt tension is correct, tighten 
the jam nuts B against the bracket.

Tighten the engine mount bolts.

Replace the belt guard.

Push engine toward the back of the plate 
by turning the adjustment bolts A to 
remove any slack in V-belt(s).

4.

3.

5.

6.

If the adjustment bolts have no 
more adjustment left, the belt(s) 
may have to be replaced.

Replacing V-Belt(s)

Loose 4 engine mount bolts (do not 
remove) only enough to move the engine 
forward.

Loosen the jam nuts B and bolts A shown 
in above figure.

1.

2.

Both V-belts should be replaced 
at the same time because they will 
wear evenly through normal use. 
Work on one belt at a time.

When adjusting the belt(s), make 
sure that the clutch pulley is in 
alignment with exciter pulley.

When removing or installing the 
drive belt(s), be careful not to get 
your fingers caught between the 
belt and pulley.

When the V-belt tension is correct, tighten 
the jam nuts B and the engine mount bolts.

Replace the belt guard.

Slide the engine toward the front of plate 
and slip the old V-belt(s) off of the wheel 
pulley and install the new V-belt(s) in their 
place.

Position the V-belt(s) over the engine pulley.

Move the engine back.

6.

3.

7.

4.

5.

V-belt

Exciter pulley

Clutch pulley

V-belt

Exciter pulley

Clutch pulley

MAINTENANCE

MAINTENANCE