Stark 65064, Owner'S Manual And Safety Instructions

15

SPARK PLUG INSPECTION

The spark plug are important components that should be checked periodically. 

1. Remove the cap and spark plug cap and insert the tool through the hole from the outside cover. 

2. Insert the handlebar into the tool and turn it counter-clockwise to remove the spark plug. 

3. Check for discolouration and remove the carbon. The porcelain insulator around the center 

electrode of the spark plug should be a medium to light tan color

4. Check the spark plug gap. 

STANDARD SPARK PLUG

: E6TC/E6RTC                                                         

SPARK PLUG GAP

: 036 - 0.7MM (0.024-0.028IN)

5. Install the spark plug. 

SPARK PLUG TORQUE:

 20.0N*m, 14.8 lb*ft)

TIP:

 If a torque wrench is not available when installing a spark plug, a good estimate of the correct 

torque is 1/4 - 1/2 turn past finger tight. However, the spark plug should be tightened to the specified 

torque as soon as possible. 

6. Install the spark plug and spark plug cover

ENGINE OIL REPLACEMENT

Avoid draining the engine oil immediately after stopping the engine. The oil is hot and should be 

handled with care to avoid burns. 

1. Place the generator on a level surface and warm up the engine for several 

minutes. Stop the engine and turn the 3 in 1 switch knob, fuel tank cap air vent 

knob to OFF. 
2. Remove screws and the cover.

3. Remove the oil filler cap. 

4. Place an oil pan under the engine, tilt the generator to drain the oil completely. 

5. Replace the generator on a surface level. 

6. Add engine oil to the upper level.

TIP:

 Do not tilt the generator when adding oil, this could result in over-filling and damage to the 

engine. 

7. Be sure no foreign material enters the crankcase. 

8. Install the filler cap. 

9. Install the cover and tighten the screws