FUEL TANK FILTER
Never use gasoline while smoking or in the vicinity of an open flame.
1. Remove the fuel tank cap filter.
2. Clean the filter with gasoline.
3. Wipe the filter and install it.
4. Install the fuel tank cap Be sure it is tightened securely.
FUEL TANK FILTER
1. Remove the screws (1) then remover the cover (2) and drain the fuel.
2. Hold and move the clamp up (4) take off the hose from the tank (5)
3.Clean the filter with gasoline.
4.Dry the filter and put it back into the tank.
5.Install the hose clamp, then open the fuel valve to check for a leak.
6.Install the cover and tighten the screws.
DRAINING THE FUEL
1. Turn the engine switch to OFF (1)
2. Remove the fuel tank cap and remove the filter. Extract the fuel from fuel
tank, then install the fuel cap.
3. Start the engine and let it run until it stops. The engine should stop in
approximately 20 minutes by running out of fuel.
4.Remove the screws, then the cover.
5. Drain the fuel from the carburettor by loosening the drain screw on the carburettor float chamber.
6. Turn the engine switch to STOP and tighten the drain screw.
7. Install the cover and tighten the screws.
8. Turn the fuel tank cap air vent knob to OFF after the engine has completely cooled.
17
Summary of Contents for 65064
Page 6: ...COMPONENTS AND CONTROLS 5 ...
Page 20: ...TROUBLESHOOTING 19 ...