IMPORTANT SAFETY INFORMATION
DO NOT overreach.
Keep proper footing and balance at all times.
2
Remove adjusting tools, shovels, hand trowels etc. Make sure all adjusting tools and equipment
are removed from the mixer prior to turning it on.
Check for damaged parts before each use.
Carefully check that the product will operate properly and
perform its intended function. Replace damaged or worn parts immediately. Never operate the
product with a damaged part.
Keep a safe clearance around the Cement Mixer.
Keep all people a minimum of six feet away from
the mixer during operation.
NEVER stick your hands and/or tools into the drum assembly while the mixer is in operation.
Use only accessories that are recommended by the manufacturer for use with your product.
Accessories that may be suitable for one product may create a risk of injury when used with another tool.
Never use an accessory that has a lower operating speed or operating pressure than the tool itself.
DO NOT leave the tool running unattended.
DO NOT overload the mixer. Capacity is 270lbs. An overload may damage the equipment.
DO NOT move the mixer during operation. The mixer could tip over and damage the engine.
Prolonged exposure to noise levels above 85 dBA is hazardous to hearing. Always wear ANSI
approved hearing protection when operating or working near the cement mixer. ANSI approved
hearing protectors are highly recommended.
People with pacemakers should consult with their physician before using this product. Operation
of equipment in close proximity to a heart pacemaker could cause interference or failure of the
pacemaker.
Always operate the cement mixer on a flat surface. Operating at an angle could cause the
machine to roll or tip over during operation.
NEVER operate the mixer if it is sitting in water. Never attempt to plug in the mixer if the plug is
wet.
Always use the proper extension cord. The motor will draw a maximum of 8 amps under start
up load. Base your wire gauge on 8 amps and the length of the cord required.
SAVE THESE WARNINGS
