HAIR DRYER HD-21
ASSEMBLY INSTRUCTIONS
0
3
1.According the progress of above opening ways to
install.
2.Please loosen the screw from the front housing part
then remove the front housing, eliminate the power
cord. (Reference PICTURE 3)
3.Broke the plastic from the wire-in hole, let the cord
which was ready by you go through the hole then
connect the port to the port which was detached in
point 2(pay attention on the wireTs direction about N
and L). Please place it on the same place after you
connected.
4.If everything is ok, please load the front housing again
and tighten the screw.
5.Use the screws to root the hair dryer on the wall.
6.Insert the Pins in electrical outlet, turn on the
switch,that's ok.
How to use
Turn the general switch of power on, the hair dryer
works when you hand the hair dryer and touch the
spring button. You can adjust the shift switch to choose
the air speed and heat you want. Max as high Min as
low