3
Fig 1 Side view of the machine
1.
Grinding disc;
2.
Spark guard cover;
3.
Protection cover;
4.
Wheel cover;
5.
Housing;
6.
Lamp;
7.
Switch;
8.
Working cradle.
Operating instruction
Before work
Check network voltage
: it should conform to the data on the machine’s label.
Tool labeled with the 230 V, can be also connected to a power source with a
voltage of 220 volts.
Place the protection covers 3 and spark guard cover 2 as shown at the fig. 1.
A gap between an abrasive disk and protection covers 3 must not exceed 2 мм. The gap
must be periodically regulated.
When an abrasive disk is worn away to such degree,
that protection covers 3 cannot be set on the required distance from an abrasive disk,
a disk must be replaced (as soon as a gap will attain 5 mm).
Grinding wheels must be correctly set and revolving freely.
Set the working cradle 8.
The gap between an abrasive disk and working cradle 8 must not exceed 2 мм.
