Starke Arvid AB Tel: +46 522 - 22 000 Fax: +46 522 - 22 344
Lyckåsvägen 3
www.starkearvid.se office@starkearvid.seSe
SE-459 30 Ljungskile
Sida
7
av
25
Organisational measures
Always keep the operating instructions within reach at the site of use.
In addition to the operating instructions please observe and teach any other generally ap-
plicable statutory regulations concerning accident prevention.
Such obligations can also include providing and wearing personal protective equipment.
Please supplement the operating instructions with instructions including supervision and
reporting obligations taking into consideration operational corporate circumstances, e.g.
relating to work organisation, work processes, personnel used.
The personnel authorised to operate the device must read the operating instructions, par-
ticularly the chapter about safety instructions before starting work. It is too late to read the
instruction if work has already been started. This applies in particular to personnel who
only work on the machine occasionally, e.g. for equipping it and carrying out maintenance
work. Occasional checks should be carried out to ensure that the members of personnel
follow the instructions and work in a safety-conscious manner and are aware of risks.
If necessary or if required by regulations, personal protective equipment should be used.
Glass should only be transported with the appropriate protective equipment (safety shoes,
protective gloves, wrist protectors, helmet etc.) A helmet should be worn at all times when
transporting goods above head height.
All safety and danger instructions on the device should be complied with.
All safety and danger instructions on the device should be kept complete and in legible
condition.
If there are any safety-related changes to the device or its operation, the device should be
stopped immediately and the malfunction should be reported to the relevant office or per-
son.
No changes, attachments or upgrading work that could possibly impair safety should be
carried out on the machine without the consent of the supplier. This also applies to the in-
stallation and setting of safety equipment and valves as well as to welding on load-bearing
parts.
Spare parts must fulfil the technical requirements specified by the manufacturer. This is
always guaranteed with original replacement parts.
Vacuum hose lines should be replaced at the specified intervals or at appropriate intervals,
even if there are no recognisable safety defects.
Compulsory deadlines or those specified in the instructions for recurring tests / inspections
should be complied with
Appropriate workshop equipment is absolutely necessary for performing the maintenance
measures.
