Starke Arvid AB Tel: +46 522 - 22 000 Fax: +46 522 - 22 344
Lyckåsvägen 3
www.starkearvid.se office@starkearvid.seSe
SE-459 30 Ljungskile
Sida
8
av
25
Personnel selection and qualification
Work on/with the machine may only be performed by reliable personnel. The legal mini-
mum working age should be observed.
Use only trained or instructed personnel; responsibilities among personnel should be
clearly established for operation, equipping, maintenance, and repair.
Ensure that only authorized personnel work on the machine.
Specify a person who is responsible for operating the machine and give him/her the oppor-
tunity to refuse to comply with the safety instructions of third parties.
Personnel being trained or instructed, or who are taking part in a general training pro-
grammed, may only work on the machine when under the constant supervision of an expe-
rienced person who is familiar with this situation.
Work on the electrical equipment of the machine may only be performed by an electrician
or by trained personnel under the direction and supervision of an electrician in accordance
with the rules of electrical engineering.
Safety instructions on particular operating phases
Normal operation
Avoid all unsafe work practices.
Before starting work, become familiar with the working environment at the site of use. The
working environment includes impediments in the work and traffic area, the load bearing
capacity of the floor, and cordoning off the worksite from public traffic areas.
Take measures to ensure that the machine is only operated when safe and functional.
Check the machine for external damages and flaws at least once per shift. Report any
changes that occur (including those to the operating behavior) immediately to the respon-
sible office/person. If necessary, stop the machine immediately and secure it!
During malfunctions, the machine should be stopped immediately and secured. Malfunc-
tions should be corrected immediately.
The switching on and off procedures should be complied with, and the inspection displays
should correspond to the operating instructions.
Always stop work if it becomes dark or if visibility is poor!
