Basic Use | 5
4 | Basic Use
Pairing Process
For Starkey Hearing Technologies Remote to interact
with your hearing aid(s), you must first pair the Remote
with each hearing aid. You only need to pair one
time, as they should automatically recognize each
other when both are powered on and within wireless
operating range.
You can pair the Remote with a single hearing aid or
a set of hearing aids.
To start using the Remote:
1. Move lower switch from Lock (right)
to Unlock (left) position.
2. Power off, then power on your
hearing aid(s), and place within
12 inches of the Remote.
* Note: For a CROS hearing aid system,
power off both your hearing aid and
CROS transmitter. Power on only
your hearing aid, ensuring the CROS
transmitter remains powered off
(reference note section under
lanyard for look/feel)
3. Press and hold the HOME
button for 5 seconds.
4. After 5 seconds, both LEDs start
rapidly blinking.
5. For
a set of
hearing aids:
• If the left LED becomes solid blue for 2+
seconds and the right LED becomes solid red
for 2+ seconds, then the pairing was successful.
Otherwise, repeat steps 2 – 5.
For a
single left
hearing aid:
• If the left LED becomes solid blue for 2 seconds,
then the pairing was successful. Otherwise,
repeat steps 2 – 5.
For a
single right
hearing aid:
• If the right LED becomes solid red for 2 seconds,
then the pairing was successful. Otherwise,
repeat steps 2 – 5.
6. To verify your setup, pressing
the Volume Up or Volume Down
button should cause a hearing
aid volume adjustment.
