Attention!
In case of a tag loss or battery discharge, SMS message will be sent to the phone
and engine will be blocked when ignition is switched on. To continue a trip, put the tracker
into Valet mode (SMS command 51). Remember that all security functions are disabled in
the Valet mode!
Device registration
To register new tags and smartphones, use the Device registration mode.
Warning!
Entering Device registering mode from Valet mode is not allowed! All tags and
smartphones must be registered in one cycle. Total 5 devices can be registered
Warning!
When registering new devices, all previous tags and smartphones will be deleted from
memory, they must be registered again.
Enter to Device registration mode:
1.
Turn the tracker to Normal mode and turn ignition On.
2.
Send SMS command "reg xxxx", where xxxx is emergency disarm password indicated on the
owner's plastic card.
Attention!
If emergency disarm password is entered incorrectly 3 times, the possibility of password
re-entering will be blocked for 15 minutes and an SMS alert will be sent to owner phone number.
3.
Wait for the SMS confirmation for successful Device registration mode enter
Registration of tags and smartphones
1.
Remove battery from the tag
2.
Hold the tag button and insert the battery back. The tag LED will turn red.
3.
Release the button and check for a series of red flashes for 10 seconds.
4.
Successful registration will be confirmed by a green flash and SMS response. If the tag is not
registered, LED will turn red.
5.
Repeat steps 1 to 3 for the remaining tags.
6.
Register your smartphone with StarLine App. Smartphone successful registration will be
confirmed with SMS response.
7.
The tracker will exit Device registration mode automatically after 5 minutes or when ignition is
switched off. The successful devices registration will be confirmed with SMS notification
containing the number and list of registered devices.
Operation algorithm for the tag loss in motion
Anti-hijack mode algorithm
If the tag is lost on a trip for more than 1 minute, the SMS message "Attention! Bluetooth tag is
lost on the trip. Ignition on» will be sent to an owner.
The Anti-hijack mode allows to protect a driver from a robbery attack during a trip. After
receiving the mode enable command, tracker will block the engine every time vehicle starts to
move.
The mode enabled with SMS command 31. Disable with SMS command 30 xxxx, where xxxx is
emergency disarm password.
It is recommended to block the engine (SMS - command 31) if the car is far from an owner (for
example, in the parking lot).
M66
version №3
Карта
История
Настройки
Управление
Мой автомобиль
B
A
Период
Неделя
Вчера
Сегодня
17.11.14
11:00
23.11.14
21:45
653
км
A
31
1 min.
SMS
!
Карта
История
Настройки
Управление
Мой автомобиль
B
A
Период
Неделя
Вчера
Сегодня
17.11.14
11:00
23.11.14
21:45
653
км
A
1.
The system can be installed on vehicles with on-board voltage 12V (cars, bikes) or 24V (trucks).
2.
Before the system installation, make sure the vehicle electrical circuits are in good condition and
there are no error indicators active.
3.
Install the system in accordance with the wire connection diagram.
4.
First of all, connect the "ground" wire with the car factory ground screw.
5.
Wires assembly should made as far as possible from sources of electrical interference from ignition
coils, high-voltage wires, etc. Make sure the wires do not come into contact with the vehicle
moving parts: pedals, steering rods, etc.
6.
Tracker input power supply is allowed only after the installation is completed.
7.
Tracker installation should be carried out by only skilful master.
8.
Tracker programmed parameters should not contradict the vehicle user manual statements
General installation rules
The developer and manufacturer ScPA Starline. reserves the right to make technical
improvements that are not reflected in this manual and connection diagram.
