STARPLUS STSe Key System Installation Manual Download

Page: 3 / 94

Regulatory Information (U.S.A.)

The Federal Communications Commission (FCC)
established rules to allow the direct connection of the

STSe

to a telephone network. Certain actions must be

undertaken or understood before the connection of
customer provided equipment is completed.

Telephone Company Notification

Before connecting the

STSe

to the telephone network,

the local serving telephone company must be given
advance notice of intention to use customer provided
equipment, and must be provided with the following
information:

Telephone Numbers

The telephone numbers to be connected to the system.

STSe

System Information

The Ringer Equivalence Number is also located on
the KSU: 1.3B

The USOC jack required for direct interconnection
with the telephone network: RJ21

FCC Registration Number:

5JYMF07BV70E

Incidence of Harm

If the telephone company determines that the customer
provided equipment is faulty and possibly causing harm
or interruption to the telephone network, it should be
disconnected until repairs can be made. If this is not
done, the telephone company may temporarily
disconnect service.

Changes in Service

The local telephone company may make changes in its
communications facilities or procedures. If these
changes affect the use of the

STSe

or compatibility with

the network, the telephone company must give written
notice to the user to allow uninterrupted service.

Maintenance Limitations

Maintenance on the

STSe

System must be performed

only by the manufacturer or its authorized agent. The
user may not make any changes and/or repairs except as
specifically noted in this manual. If unauthorized
alterations or repairs are made, any remaining warranty
and the software license for the system will be voided.

Hearing Aid Compatibility

All

STSe

Digital Terminals are Hearing Aid Compatible,

as defined in Section 68.316 of Part 68 FCC Rules and
Regulations.

UL/CSA Safety Compliance

The

STSe

System has met all safety requirements and

was found in compliance with the Underwriters
Laboratories (UL) 1459. This system is authorized to bear
the “NRTL/C” marking.

Notice of Compliance

The

STSe

System complies with rules regarding

radiation and radio frequency emissions by Class A
computing devices. In accordance with FCC Standard 15
(Subpart J), the following information is supplied to the
end user:

“This equipment generates and uses RF energy
and if not installed and used in accordance with
the Instruction Manual, may cause interference to
Radio Communications. It has been tested and

found to comply with the limits for a Class A computing
device, pursuant to Subpart J of Part 15 of the FCC Rules,
which are designed to provide reasonable protection
against such interference, when operated in a commercial
environment. Operation of this equipment in a residential
area is likely to cause interference, in which case the user, at
his own expense, will be required to take whatever
measures may be required to correct the interference.”

“

WARNING

: Handling the cord on this product will

expose you to lead, a chemical known to the State of
California to cause [cancer, and] birth defects or other
reproductive harm.

Wash hands after handling

”

Toll Fraud and DISA Disclaimer

“While this device is designed to be reasonably secure
against intrusions from fraudulent callers, it is by no
means invulnerable to fraud. Therefore, no express or
implied warranty is made against such fraud including
interconnection to the long distance network.”

“While this device is designed to be reasonably secure
against invasion of privacy, it is by no means
invulnerable to such invasions. Therefore, no express or
implied warranty is made against unlawful or
unauthorized utilization which results in the invasion of
one’s right of privacy.”

Vodavi has made every reasonable effort to ensure that
this product works in most business environments.
However, there may be some environments (RFI and EFI)
in which this product may not work properly. In such
cases, it is the responsibility of the installer to take the
necessary actions to correct the situation.