TDA025 INSTRUCTION MANUAL 7
HOW TO REMOVE THE LOWER BLADE
PUTTING THE NEW BLADES ON
HOW TO ADJUST THE UPPER BLADE
1. Remove the screw.
2. Pull out the lower blade.
Note: If you cannot take
the lower blade off,
use the manual lever
to cycle the cutter,
this will raise the
lower blade.
Perform the blade removal steps in reverse.
Be sure to
firmly
insert the lower blade and arm frame.
1. Use the two adjustment screws behind the blade. Adjust the upper blade inward by
alternately tightening the two screws.
Note: If you force the blade out, it might collide with the lower blade.
2. Load the tape and try to cut it.
3. Once the adjustments are correct,
tighten the top screw firmly.
4. Try to cut the tape again. If the
tape cuts, you have performed the
adjustment correctly.
Note: If the tape is not cut per-
fectly, turn the adjustment
screw a little at a time to
further adjust the blade.
Summary of Contents for TDA025
