Instruction Manual
3
Doors
There are 2 doors on each cabinet. Both the front and rear doors are removable. To
remove them
1. Pull down the top tab while holding the door with the other hand. The top
should fall out of place.
2. Pull up on the bottom tab and lift door out of the frame. The same method can
be applied to the rear door.
Changing the Door Position
1. Inside the top corner of the door frame, pull down the Door Hinge Release Tab.
2. While holding the top Door Hinge Release Tab, tilt the bottom on the door
forward and lift the bottom Door Peg out of the Mounting Hole and set the door
aside.
3. Using a Phillips Head Screwdriver, remove the two screws holding the Locking
Plate in place.
4. Using a Phillips Head Screwdriver, remove the two door stoppers from the top
and bottom of the door frame.
5. Insert the bottom Door Peg into the Mounting Hole on the door frame. Keeping
in mind the orientation on the Door Handle.
6. Pull down the top Door Hinge Release Tab and align the Door Peg with the
Mounting Hole. Release the Door Hinge Release Tab once the Door Peg is aligned
with the Mounting hole.
7. Align the Lock on the Door with two of the Mounting Nuts on the slide rail.
Ensuring that when the Locking Plate is attached to the Mounting Nuts that the
Locking Plate will catch the Door Lock when the door handle is turned.
Note:
When attaching the Locking Plate use two of the middle Mounting Nuts leaving
at least one Mounting Nut on either side, for use when attaching the Door Stoppers.
8. Align the Locking Plate with the two Mounting Nuts on the Slide Rail, making
sure that the raise portion of the Locking Plate is facing out.
9. Insert the two Locking Plate Screws through the Locking Plate and into the
Mounting Nuts. Tighten the screws using a Phillips Head Screwdriver.
10. On the same side of the door frame as the Locking Plate, align a Mounting Nut in
the top and bottom corners on Slide Rail.
11. Align the Stoppers with the Mounting Nuts positioned in step 10.
12. Insert a Stopper screw through the Stopper and into the Mounting Nut. Tighten
the screws using a Phillips Head Screwdriver.
Summary of Contents for 2636CABINET
Page 7: ...Instruction Manual 4...