StarTech.com 2636CABINET, Manual

Instruction Manual

2

Unpacking the Rack

Warnings: 

The Rack is heavy and you should exercise caution when you remove it 

from the pallet. 
At least three people are required to unpack the Rack. Do not attempt to unpack the 

Rack by yourself.

1.  Carefully move the shipping pallet to a level surface.
2.  Using a Socket and Wrench, remove the Bolts from the Brackets.
3.  Carefully remove the Rack from the pallet and place it on a firm surface. 

Securing the Rate to the Floor

You can use the Brackets and Bolts used to secure the Rack to the shipping pallet to 

securely fasten the Rack to the floor.

1.  Carefully place the Rack onto a flat surface.
1.  Align the Bracket with the Bracket Hole on the Rack.
2.  Insert two of the Bolts through the Bracket and into the Rack. Tighten the Bolts 

using a Socket and Wrench.

3.  Insert the other two Bolts through the Bracket and into the surface you are 

securing the Rack to.

Note: 

Pilot holes may need to be drilled in the surface you are securing the Rack to 

prior to installing the Bracket.

Installation

Posts

Depending on the size of the device you are mounting or the type of mounting 

brackets that are used, you may want to move the posts forward or back, or replace 

the cabinets posts. To do this, simply remove the front and back posts from the fixed 

rails by removing the screws which secure them to the rails. Move the nuts to the 

location where you would like the post to go. Align the holes on the posts with the 

nuts and secure the posts to the rails.

1.  For the posts you will need to insert the cage nuts, which are supplied, where you 

would like the device to go. To insert the cage nut press on either side of the nut. 

Insert the clamps into the hole and release the nut. Screw the device into place.

2.  If your device has mounting brackets with hooks, just hook the bracket to the 

position where you want your device to go.