Contents
• 1 x Multi-Card Reader
• 1 x User Manual
• 1 x Driver CD
• 1 x USB Type A to B cable (for Standalone use)
• 1 x USB Type B to motherboard header cable
• Four Screws
• Four Rubber Pads
IIn
ns
stta
alllla
attiio
on
n
Panel Installation
Note
: The instructions below outline how to install the card reader into a 3.5” drive bay.
Alternatively, you can use your card reader externally by plugging the USB cable into an
open USB port.
1. Make sure that your system is unplugged and you are grounded.
2. Remove the cover of your system and remove the cover from a 3.5” drive bay (see
your computer’s user manual for details, if necessary).
3. Gently insert the panel into the open 3.5” bay (after threading the attached USB
cable into the computer) until it is flush with the front of the case. Make sure the
bracket is lined up with the screwholes in the case, and screw the panel into place.
4. Connect the reader to the mainboard, using the 1 x 4 pin header to USB Type ‘B’
cable. Based on the following table, please ensure that the pin assignments are
correct:
5. Replace the cover on the computer.
6. Your computer will display a message saying new hardware has been found.
Windows 98SE and 2000 users follow the on-screen prompts and direct Windows
to the appropriate folder on the driver disk. Windows will install the necessary drivers.
Driver Installation
Note:
This section assumes that your computer system already has a USB 2.0 port
available for connecting the card reader and all of the appropriate drivers have been
installed for the USB port.
Instruction Manual
2
Pin 1 (Red)
Pin 2 (White)
Pin 3 (Green) Pin 4 (Black)
USB 5V
DATA-
DATA+
GND
