Instruction Manual
6
Troubleshooting Swap Manager
If you have installed a new drive but there is no new icon listed in Swap Manager, first
make sure that you have clicked the Swap In icon to let Swap Manager know that there
is a new drive. If that does not work, check the following:
•
Make sure that the hardware is properly installed and that all cables are properly
connected and firmly seated.
•
Make sure that the drive bay is connected to the secondary SATA channel. The
primary SATA channel is not accessed by Swap Manager.
•
Make sure that the drive caddy is firmly seated in the bay and that the bay has been
locked. If the bay is not locked, no power will be supplied to the drive and Swap
Manager will not detect it.
Monitoring Your Hard Disk Drive and Drawer
The status LED is located on the right side of the drive drawer. It is your best indication
of the hard drive’s status, and is lit when the drawer is successfully inserted and locked
into the caddy.
The Fan Status LED located on the left side of the drive drawer indicates fan failure.
When lit up, a problem with the cooling fans has been detected..
NOTE:
It is recommended that you avoid removing a drawer during hard disk activity,
as doing so could damage the drive and/or data.
