Instruction Manual
10
Host:
Enter the SMS server address.
Transmission Mode:
Select the transmission mode.
Device Name:
Enter a name/subject to identify the device.
Account:
Enter the account name if required.
Password:
Enter the password if required.
Message Format:
Click the icon to the right of the format text box to see a preview of
the message format.
Save:
Saves all changes.
SNMP/SysLog Tab
Configure SNMP Traps and System Logs to be sent to different Network Management
Stations (NMS).
SysName:
Enter the name of the SNMP device.
SysContact:
Enter the name of the System Administrator.
SysLocation:
Enter the location of the SNMP device.
Host:
The IP Address of the NMS of where the Traps should be sent.
Port:
The port that will be used to receive the Traps. The default value is 162.
Write Community:
Low-level password of the associated IP address with the access
type set by the administrator.
Enabled:
Enables the SNMP Traps to be sent.
SNMP Test:
This is used to verify that the Trap notification works properly.
Save:
Saves all changes.
