2
Remove the chassis cover from your computer.
2.
Locate an unused PCI Express slot (typically white and smaller) and
3.
remove the corresponding slot cover from the rear of the computer
chassis. NOTE: the Host card uses a PCIe x1 connector, so it can
be installed into any sized PCIe slot (ie. x1, x4, x8, x16, etc.)
Plug the PCIe add-in card to the unused PCI Express expansion slot
4.
and attached the card bracket to the computer chassis with a screw.
Put the chassis cover back on the computer.
5.
Install one end of the Expansion Cable to PCIe add-in card’s
6.
connector and the other end to the Expansion Box’s.
Warning!!
The Expansion Cable’s connector has the same form factor
as a standard DVI connector, however, their signals are different.
Please do NOT connect the Expansion Cable to either your LCD
monitor nor your Video Graphic cards.
Next, install the PCI and PCIe add-in cards into the Expansion Box:
7.
Open the top cover (by removing the screws) of the Expansion
a.
Box. There are 2 PCI and 2 PCIe slots in the Expansion Box.
Find an unused slot, remove the “blank” PCI/PCIe card bracket
b.
that was pre-installed from the factory.
Plug in your PCI or PCIe add-in card (s).
c.
Put the top cover back on your Expansion Box.
d.
PCI Express
PCI