Instruction Manual
2
Installation
WARNING!
Hard drives require careful handling, especially when being transported. If
you are not careful with your hard disk, lost data may result. Always handle your hard
drive and storage device with caution.
Hardware Installation
1. Remove the two small screws from either side of the rear panel of the enclosure and
then pull the rear panel out.
2. Slide a 2.5” SATA hard drive into the 7+15 SATA connector on the inside of the rear panel.
3. Fasten the hard drive to the rear panel from the bottom, with the supplied screws.
4. Slide the hard drive and rear panel back into the enclosure and reinstall the two side
screws for the rear panel.
