13
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Push Button Control
Selecting a Connected Computer
•
Press the
Port Select Button 1 - 4
to toggle between the
ports.
Activating Auto Scan
The
Auto Scan
function allows you to scan through the
computers connected to the
KVM Switch
in sequence.
•
Press and hold
Port Selection Buttons
3 and 4
simultaneously.
Note:
When a computer is being scan the corresponding
Port LED
will flash.
Deactivating Auto Scan
To deactivate
Auto Scan
in the middle of a scan:
•
Press one of the
Port Selection Buttons
to stop the auto
scan.
Setting Scan Time
You can set the scan time duration used within the
Auto Scan
function from 3 seconds to 30 seconds.
•
Press and hold
Port Selection Buttons
1 and 2
simultaneously.
Note:
The
KVM Switch
will beep each time you enter the
hotkey up to 4 beeps indicating the duration of the scan
rate 1 beep = 3 seconds, 2 beeps = 8 seconds, 3 beeps = 15
seconds, and 4 beeps = 30 seconds.
