StarTech.com USBDUPE17, User Manual

Instruction manual

14

Update the system firmware

1.  Save the firmware update onto a USB flash drive that is formatted to FAT32.

Note:

 Make sure that the firmware update file is unzipped and not in a folder.

2.  Use the Power switch to turn on the duplicator and eraser.
3.  Insert the USB flash drive into one of the USB flash drive ports.
4.  Highlight 

Utility

 and press the OK button.

5.  Highlight 

System Update 

and press the OK button.

6.  When the confirmation message appears, press the OK button.
7.  When the firmware update is complete, move the Power switch to the off position.
8.  Wait a couple of minutes and then turn on the duplicator and eraser again.

Calculate the checksum number

You can calculate the checksum number of the source USB flash drive. The checksum 

area that is calculated is based on the copy area that is set.

1.  Use the Power switch to turn on the duplicator and eraser.
2.  Insert a USB flash drive into the Source USB flash drive port.
3.  Highlight 

Utility 

and press the OK button.

4.  Highlight 

Calc. Checksum

 and press the OK button.

When the calculation is complete, the checksum is displayed on the LCD display.

Measure read and write speeds

You can measure the read and write speeds of the destination USB flash drives.

1.  Use the Power switch to turn on the duplicator and eraser.
2.  Insert up to seven USB flash drives into the Destination USB flash drive ports.
3.  Highlight 

Utility

 and press the OK button.

4.  Highlight 

Measure Speed 

and press the OK button.

5.  To view the read and write speeds for each of the USB flash drives, use the UP and 

DOWN buttons to move through the list of the USB flash drive ports.