Instruction manual
15
Analyzing the quality of a USB flash drive
You can use the media check feature on the duplicator and eraser to check the quality
of a USB flash drive. You can also change the range and error limit of the media check
feature.
Perform a media check
There are three types of media checks that you can perform: H3 Safe, H5 RW, and H6
SafeRW. When you select the H3 Safe media check, the system reads the USB flash
drive to assess its quality. When you select the H5 RW or H6 SafeRW, the system reads
and writes to the USB flash drive to assess its quality.
Warning!
When you complete the following steps, some or all of the data on your USB
flash drive might be deleted. If your USB flash drive has data on it that you require, you
should create a backup file or use a different USB flash drive.
1. Use the Power switch to turn on the duplicator and eraser.
2. Insert up to seven USB flash drives into the Destination USB flash drive ports.
3. Highlight
Utility
and press the OK button.
4. Highlight
Media Check
and press the OK button.
5. Do one of the following:
• Highlight
H3 Safe
and press the OK button.
• Highlight
H5 RW
and press the OK button.
• Highlight
H6 SafeRW
and press the OK button.
When the process is complete, you can view the number of bad sectors detected and
the read/write speed of the USB flash drive on the LCD display.
Change the range limit percentage
You can select the percentage of the USB flash drive that you want to quality check.
1. Highlight
Utility
and press the OK button.
2. Highlight
Media Check
and press the OK button.
3. Highlight
Setup Range %
and press the OK button.
4. Highlight a percentage between 1 and 100 and press the OK button.
