Instruction Manual
8
Operation
EDID copying
Use PC mode to copy (clone) the EDID settings from your display for use with a
computer.
1. Set the
Mode switch
on the EDID Copier to
PC mode
.
2. Use the included screw driver to set the
Rotary dial
on the EDID Copier to position
0 or 1
.
3. If your video source is HDMI, use the included screw driver to set
Dip switch
6
in the
OFF
position (down).
or
If your video source is DVI (using an HDMI adapter), use the included screw driver to
set
Dip switch
6
to the
ON
position (up).
4. Set the remaining
Dip switches
to your desired setting based on the requirements
for your application (see Dip switches section, page 6).
5. Connect the included USB power cable to the
Power port
on the EDID Copier and
to a USB power source.
6. Connect an HDMI cable (not included) to your display device and to the
HDMI
output port
on the EDID Copier.
7. Press and hold the
EDID copy
button on the EDID Copier until the
Status LED
starts
to flash green. When you release the
EDID copy
button, the
Status LED
will then
flash green and red alternately, indicating that the EDID Copier is actively copying
the display’s EDID settings. The LED will then light blue, indicating that the EDID
copy process has successfully completed.
8. Disconnect the EDID Copier from your display and reconnect your display to the
video output on the third-party equipment that is causing the disruption.
9. Connect an HDMI cable (not included) to your video source and to the
HDMI input
port
on the EDID emulator.
10. Connect an HDMI cable (not included) to the EDID emulator’s
HDMI output
port
and to the video input port on the third-party equipment that is causing the
disruption.
11. Verify the signal has been corrected by viewing your display.
